![]() ![]() Again, nothing that can't be sanded down with some care. The base of the model printed slightly warped, likely due to the logo & large flat surface. This is likely less of an issue on the larger scale sculpt where it would be less noticable. Because the pieces are so fine, it's a little difficult to sand & clip them down for fear of breaking them. It might be nicer to have more lighter supports than the heavy ones.They were especially prominent on the swords. In some ways this is good because it's less likely to fail, but they were slightly challenging to remove and left a good few bumps on the model. Because i got the file on sale it was only about 17$, with the cost of resin it was likely under 20$ for the entire thing (I didn't keep exact track because I jammed some other stuff on the build-plate as well), which compared to trying to buy an official model is much cheaper.Ĭons: The pre-supports are really thick. The print didn't use too much resin and seemed fairly well optimized for printing, but i'm a beginner so i'm no expert. I know it's a minor thing, but it really does make the process of going from download to print much more enjoyable to have an organized download rather than a jumbled mess of randomly named files. The files are also well named and well organized. There are multiple sizing options which is great for someone like me who wants a small desk-top model, but someone else might like something bigger. ![]() The file comes in different formats, and is easy to edit and add extra supports if you'd like. I had no issues with the pre-supports when printing. The base is really interesting, 2b looks great, her swords print amazing. I think it does a great job representing how cool the character can be, rather than just being a pin-up. ![]() So many of the Nier inspired scuplts are super sexualized (to each their own), but this one is fairly tame, super detailed, and really cool. Pros: The sculpt is dynamic and extremely well detailed. Really looking forward to painting it up! I am really new to 3d printing and it worked like a charm. I used the Mercury 2-in-1 to clean & cure the prints. I used Elegoo's Ceramic Grey water washable resin. I used the pre-supported files but added a few extra supports myself. Recommended The print turned out great! I printed mine off the Elegoo Mars 3 pro, at the 75mm scale. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |